(figure 2 Make sure the wire with the loop on the end falls through the slot on the bottom of the clock. (figure 1) Remove them as well as the paper strip on the coiled gong. There are two wire clips around the bellows. If the method of fitting these pieces isn’t completely obvious, please don’t hesitate to contact your dealer for help.ĥ. Many clocks have a few decorative pieces which fit on in various ways. Take a look at the picture on our website and compare your clock. Simply slide these pieces over their corresponding pegs. There may be other little decorative pieces on your clock. If you have a horn bell, push it into the hole near the dial. Simply make sure there is enough tension on these clips and slide them over the edge of the cuckoo roof.Ĥ. A fourth method of attaching the top piece also exists: the clips. They should be just tight enough to hold the top piece in place. Be careful not to over-tighten these screws. There should already be holes drilled in the top to receive these screws. Some high-end cuckoo clocks have top pieces that attach with small screws. Rather than pins, some clocks have screws which slide into saddles thereby holding the top in place. You may have to turn the pins so they are perpendicular to the holes. The top should have two bent pins which correspond to two holes in the roof of the clock. Push the antlers into the holes at the top of the head so that they curve up and away from the front and center of the clock.ģ. Drive the screw through the hole in the shield and into the back of the head were a hole has been started. Use the screw included to attach the deer head to the shield. If your clock has a deer head with antlers, you may assemble that first. If you have a chalet cuckoo clock, your clock will not include a top piece.Ģ. If you have a traditional carved hunting model your box will include the following: clock, top piece, deer head, antlers (left and right), horn bell, pendulum, and either two or three heavy weights. Be sure to unwrap each of the other paper bundles as there may be tiny pieces inside. For now, leave the chains on the bottom of the clock wrapped. After removing the clock from the box, unpack each of the items carefully.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |